Pitney Bowes da95f Operator's Manual page 53

27. Press Menu to go back to the previous screen. Use the (+) key
to scroll to the next adjustment. The MODULE DISTANCE to
Sensor screen displays.
28. Press Enter. The MOD TO SENSOR screen displays.
29. On the test pattern that you printed, there is a solid vertical bar at
the far right edge of the pattern. Carefully measure the distance
from the right edge of the bar to the edge of the media that the
test pattern sample printed on.
•
If the gap measures exactly .25 in (6.35 mm), then no
adjustment is necessary. Skip to step 32.
•
If the gap is not exactly .25 in (6.35 mm), go to step 30.
30. You will need to align the print heads to the sensor if the gap
between the solid vertical bar and the right edge of the material
it's printed on does not measure .25 in (6.35 mm). The number
on the MOD TO SENSOR screen represents the actual distance
from the sensor to the print head you are aligning. You will need
to increase or decrease that distance. You will use the gap
measurement that you got from the test print to determine how
much to increase or decrease this number by.
Use the 3 samples on the following page to help you determine
the value you should enter.
SV61749 Rev. D
Printer Maintenance • 3
Sensor Gap Measurement
Head 1
Head 2
Head 3
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
9
9
0.25" Gap
3-9