Pitney Bowes da95f Operator's Manual page 15

1 • Introduction
Optional
High Speed
FeedRight™
Feeder
Analog Phone Port - Used to communicate with high speed
FeedRight™ feeder and optional stackers.
Control Panel - Use the control panel buttons to access printer
menus, define print options, run the print job, and turn the
printer on and off line. If you have the print driver loaded on your
computer, you can easily perform these functions from within
your application.
Exit Rollers - Guide the material out of the printer.
Feed Ramp - The feed ramp adds a gentle slope to the bottom of the
material stack to help feeding.
Feed Ramp Adjustment Lever - Adjust the position of the feed ramp
along the input guide using this knob.
Feed Tires - When you switch from one material type to another, you
need to set the gap between the separator assembly and the
feed roller before printing begins.
Separator Assembly - Adjust to the thickness of your material. The
gap between the separator assembly and the feed rollers should
be just enough to allow a single piece to feed through the printer.
Idler Rollers - Guide the material through the print head area.
Input Guide - Where you stack material for printing. Adjust the angle
to accommodate the weight of the material you're running.
Input Guide Angle Adjustment Knob - Locks the input guide into
position.
Media Thickness Knob - The media thickness knob sets the
1-8 SV61749 Rev. D