Pitney Bowes da95f Operator's Manual page 55

31. Scroll using the plus (+) and minus (-) keys to change the
number on the display. Press Enter. You have completed the
Print Head Sensor Alignment. Go to step 32 to print a test
pattern.
32. Ensure material (paper, envelope, etc.) is loaded in the printer.
Press the Test Env key. A test pattern will print. Verify that your
test pattern looks like the example provided.
T's are touching
and aligned
Rectangle
is straight
• If your test pattern matches the example, and you have not
replaced any ink cartridges in print head assembly B, then
you have completed the print head alignment procedure.
• If your test pattern matches the example, and you have
replaced ink cartridges in print head assembly B, then you
have finished aligning print head assembly A, and you will
now need to perform the alignment procedure for print head
assembly B. Go to step 33.
• If your test pattern does not match the example, repeat the
print head alignment procedure for assembly A (steps 1-32).
SV61749 Rev. D
Printer Maintenance • 3
Lines are straight and
unbroken
.
Rectangle is straight and
is .25 in (6.35 mm) from
right edge of test material.
3-11