Advertisement
5.
SEA WATER PUMP #32617 IMPELLER REPLACEMENT
The following instructions are general and indicative only.
Specific
instructions where applicable may be packaged wi th your replacement
impeller.
(a)
Remove the four screws and washers that hold the front cover to
the pump body.
Remove the cover and gasket.
(b)
Grasp the impeller hub wi th a pair of pliers and withdraw the
impeller.
(c)
Apply a small amount of petroleum jelly to impeller blade ends of
new impeller.
Line up impeller hub screw with slot in pump shaft
and
insert
impeller
into pump until flush with cover mounting
surface.
(d)
Immerse the new gasket in water for a moment before installing.
Install the gasket, cover, screws and washers.
Note:
No
sealant
is
needed
on
the
cover
gasket
for
proper
sealing.
In you intend to reuse the cover gasket, immerse it in
water until reassembly of the cover.
The gasket will shrink when
dried out.
i ,
~r
','" ,/
~~,'~'"",.,>.-
--
'/~/
.'
Y
~'
..
~/
..
6.
SEA WATER PUMP #32617 - SEAL REPLACEMENT
(a)
Remove the pump from the mounting bracket and remove the dr ive
pulley.
(b)
Remove the front cover and impeller as above.
Remove the cam and
inner wear plate.
(c)
Remove the plastic bearing shield from the pulley shaft end of
the pump with the aid of a small screwdriver.
Push through the
small recess in the outer circumference of the shield and pry it
out.
With snap ring pliers, remove the large outer snap ring
positioned in the pump body.
108
Advertisement
