Advertisement
ASSEMBLY INSTRUCTIONS
STEP2： ： ： ：
1. Remove two M10×20mm Hex Bolts (72) and two M10 Washers (78) from two Weight Guide
Tubes (3).
2. Insert the Weight Guide Tube (3) into the Rear Base (2), using two M10×20mm Hex
Bolts (72) and two M10 Washers (78).
3. Slide the two Rubber Rings (32) onto the two Weight Guide Tubes (3).
4. Slide the nine Weight Plates (34) down Weight Guide Tube (3).
5. Slide Selector Shaft Bushing (37) down Weight Selection Rod (27) at First hole fix with
Selector Shaft Pin (27).
6. Insert Weight Selection Rod (27) into hole of Weight Plate (34).
7. Slide Top Plate (33) down Weight Selection Rod (27), Insert Weight Selector Pin (27) into
hole of desired Weight.
4
Advertisement
