Chapter 5: Manager Mode; Using Manager Mode; Manager Mode Overview - Matrix T3X-05 Service Manual

5.1 USiNG maNaGer mode

1) To enter Manager Mode, press & hold INCLINE DOWN and
SPEED DOWN keys at the same time for 3-5 seconds until Manager
appears on the display.
2) To enter the Manager Mode, press ENTER once Manager Mode
appears on the display (Figure A).
3) To scroll between settings in the Manager Mode, press the
INCLINE or SPEED keys.
4) Press ENTER to modify the settings once displayed.
5) Press any INCLINE or SPEED key to change the value of the set-
ting.
6) Press the PAUSE key to exit the setting without saving.
7) Once the setting is correct, press ENTER to save.
8) Press the EMERGENCY STOP to exit Manager Mode..

5.2 maNaGer mode oVerVieW

CUSTom defaUlT
SeTTiNGS
MAXIMUM TIME 60
DEFAULT TIME 20
DEFAULT LEVEL 1
DEFAULT AGE 30
DEFAULT 150 LB / 68
WEIGHT KG
ACCUMULATED N/A
DISTANCE
ACCUMULATED N/A
TIME
SOFTWARE N/A
START SPEED 0.5 MPH /
0.8KPH
MAXIMUM 12 MPH / 20
SPEED KPH
TIMER MODE DOWN
SPEED MODE MILE
OUT OF ORDER OFF
GENDER MALE
LANGUAGE ENGLISH
SOUND MODE ON
BELT STOP OFF
NAVY TEST 0
SITE
HRT SPEED OFF
BASED
12

CHaPTer 5: maNaGer mode

miNimUm maximUm
5 99
5 99 (limited to max
time setting)
1 10
15 100
50Lb/23KG 400Lb/182KG
N/A 65,000 MILES /
104,000KM
N/A 65,000 HOURS
N/A N/A
0.5 MPH / 0.8 2.0MPH/3.2KPH
KPH
2.0 MPH / 3.2 12MPH/20KPH
KPH
DOWN UP
MILE KILOMETER
OFF ON
MALE FEMALE
N/A N/A
ON OFF
OFF 30, 60, OR 90
SECONDS
0 1
ON OFF
fiGUre a
UNiT DESCRIPTION
MINUTE Maximum workout duration.
MINUTE Default start time in all programs.
LEVEL Default start level in all programs.
AGE Default age used in HR programs.
POUND / Default weight used in calorie calculations
KILOGRAM and HR programs.
MILE/KILOMETER Total distance on treadmill, not editable. TO
RESET: Press and hold INCLINE DOWN and
SPEED DOWN for 3-5 seconds.
HOUR Total time on treadmill, not editable. TO
RESET: Press and hold INCLINE DOWN and
SPEED DOWN for 3-5 seconds.
N/A Software Version, not editable.
MPH/KPH Controls the starting speed for all programs
(does not affect minimum speeds).
MPH/KPH Controls the maximum speed for all
programs.
N/A Controls whether the user time counts up or
down.
N/A Measurement unit used for calorie
calculations, distance, and speed.
N/A Locks the machine.
N/A Sets the user's gender.
N/A Sets the language shown on the console.
N/A Controls whether the display broadcasts
chime when buttons are pressed.
SECONDS This option checks for a user on the running
belt. If there is no user detected, the unit will
go into pause mode, and reset if no user for
5 minutes.
N/A 0 : Test site elevation less than 5000 ft above
sea level.
1 : Test site elevation greater than 5000 ft
above sea level.
N/A This option allows the user to choose speed
based type in setup screen of target heart
rate program.