Remote Control Problems; Audio Problems - Eiki EK-800U Owner's Manual

DLP Projector — Owner's Manual
5.
Replace the lamp module.
6.
Put the old lamp back in the projector and have the projector serviced.
Problem: The lamp goes off
1.
Power surges can cause the lamp to turn off. Re-plug power cord. When the Lamp 1/Lamp2 LED
is flashing red, press "
projector.
2.
Replace the lamp module.
3.
Put the old lamp back in the projector and have the projector serviced.

Remote Control Problems

Problem: The projector does not respond to the remote control
1.
Direct the remote control towards remote sensor on the projector.
2.
Ensure the path between remote and sensor is not obstructed.
3.
Turn off any fluorescent lights in the room.
4.
Make sure that the batteries are installed with the correct polarity.
5.
Replace the batteries.
6.
Turn off other Infrared-enabled devices in the vicinity.
7.
Have the remote control serviced.

Audio Problems

Problem: There is no sound
1.
Adjust the volume of the audio source.
2.
Check the audio cable connection.
3.
Test the source audio output with other speakers.
4.
Have the projector serviced.
5.
Have the remote control serviced.
Problem: The sound is distorted
1.
Check the audio cable connection.
2.
Test the source audio output with other speakers.
3.
Have the projector serviced.
" on the built-in keypad or press "
—
" on the remote control to turn off the
58
—