Moving The Projector; Installing The Projector Properly - Eiki EK-800U Owner's Manual

Hide thumbs Also See for EK-800U:

Table of Contents

DLP Projector — Owner's Manual

Moving the projector

When moving the projector, take care of the lens and retract the adjustable foot to prevent damage to the

lens and cabinet.

• Please set the projector on nearly-level.

• Be sure to install the projector properly. Improper installation may reduce the lamp lifetime and even

cause a fire hazard.

Caution in ceiling installation the projector

• Only qualified personal is authorized for ceiling installation.

• We are not responsible for the hurt and damage caused by ceiling brakect that purchased from

unauthorized dealer even in warranty period.

• Remove the ceiling bracket immediately while not use.

• While installing, torque screwdriver is suggested, don't use electric or impact-type screwdriver.

• Please read the manual of bracket for details.

• The bracket is subject to change without notice.

Air Intake Vent

Do not roll the projector over 15 degrees from rear to front.

Do not point the projector up to project an image.

Do not point the projector down to project an image.

Do not put the projector on either side to project an image.

Exhaust Vent

viii

—

Table of Contents