Hardware Installation; Mounting The Smartnode 2300 - Patton electronics SmartNode 1200 Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide

Hardware installation

SmartNode 2300 installation consists of the following:
Note
• Installing an interface card (if the card was not installed at the factory). Refer to chapter 9,
installation" on page 122 to install the card, then return to this chapter.
• Placing the device at the desired installation location (see section
page 86)
• Installing the interface and power cables (see section
When you finish installing the SmartNode 2300, go to chapter 10,

Mounting the SmartNode 2300

The SmartNode 2300 should be placed in a dry environment with sufficient space to allow air circulation
for cooling.
Note
The SmartNode 2300 can be installed as follows:
• Placed on a desktop or similar sturdy, flat surface that offers easy access to the cables
• Mounted inside a 19-inch equipment rack
Note

Hardware installation

If you will be installing the 48V line power module prior to installing
an interface card or ISDN S-Bus, refer to chapter 8,
module installation" on page 114.
For proper ventilation, leave at least 2 inches (5 cm) to the left, right,
front, and rear of the SmartNode 2300.
To prevent overheating, Patton recommends that the SmartNode
2300 not be installed in a closed rack or in a room that is not prop-
erly ventilated or air-conditioned.
6 • SmartNode 2300 installation
"Line power

"Mounting the SmartNode 2300"

"Connecting cables" on page 89)
"Quick start"
"Interface card
on
on page 126.
86