Installing The Ic-E1V Interface Card Cables - Patton electronics SmartNode 1200 Getting Started Manual

SmartNode 1000 and 2000 Series Getting Started Guide
S LO
T 4
S LO
T
3
S LO
T
2
RJ-45, male
Rx+ 3
Tx- 4
Tx- 5
Rx- 6

Installing the IC-E1V interface card cables

The PRI is usually connected to a PBX or switch (local exchange (LE)). Type and pin-outs of these devices vary
depending on the manufacturer. In most cases, a straight-through RJ-45 to RJ-45 can be used to connect the
PRI (see table 36 for IC-E1V card port pin-out listing) with a PBX. A cross-over cable is required to connect to
a NT1, as illustrated in
Note
WARNING
CAUTION
Connecting cables
S LO
T
1
S-Bus cable
Figure 74. Connecting a BRI to an NT
figure 75 on page 109.
Table 36. RJ-45 socket
Pin
1
2
3
4
5
6
Pins not listed are not used.
Hazardous network voltages are present in the PRI cables. If you detach the
cable, detach the end away from the SmartNode or interface card first to avoid
possible electric shock. Network hazardous voltages may be present on the
device in the area of the PRI port, regardless of when power is turned OFF.
To prevent damage to the system, make certain you connect the
PRI cable to the PRI port only and not to any other RJ-45 socket.
7 • SmartNode 2400 installation
USR
TX Tip
TX Ring
TX Shield
RX Tip
RX Ring
RX Shield
NT
RJ-45, male
3
4
5
6
108