Brief Description Of The Panel Status On Keypad Display; Low Battery - 3i Dualnet-6 Instruction Manual

Brief description of the panel status on keypad display:

While panel is not armed press
the keypad will return to normal status.
NOTE: In the case you see, on keypad, "NO SIM CARD" even if the SIM card has been put in,
remove all power to the panel (230vac and 12vdc), Check that the SIM card has been correctly
installed and power up the panel again.
The following info will be displayed on the keypad once there is an event:
Information seen on display
YYYY. MM. DD.
HH:mm:XX:Day
GSM Signal Strength:
XX :YY
No SIM Card: XX:YY
ARM :YYYYYY
HH:mm:XX:Day
Phone Cut (*)
Power Failure (*)

Low battery(*)

System Armed
XX YYYYY
Communicating 00 YYYY (*)
Not ready
XX YYYYY
(*) This is active only if the setting is (Y) in the CMS management menu. (see pag.17)
DUALNET—6 INSTRUCTION MANUAL
or to have the GSM status information; After 20 seconds
Meaning of information seen
On the keypad display you will see:
YYYY= year, MM=month, DD=day
Followed buy:
HH= hour (format 12h), mm= minutes
XX=AM or PM, Day= day of week
GSM signal level XX = 8 and above is
"OK" is seen. If XX = 7 and below "NO"
is seen.
XX = signal strength from 8 to 10
YY = "OK" or "NO"
Panel ARMED in YYYYYY= Day or
Night HH = hour : MM = minutes XX =
AM or PM : Day =DAY of week
PSTN line fault
Mains 230V ac. Not present.
Normal battery output 13.8 V. If it goes
below 10 V, Display = Low battery.
Zone triggered: XX zone number
YYYY zone description
Send message to memorized telephone
numbers using (SMS or CONTACT ID)
Armed
Disarmed
Low battery
Battery OK
Mains failure 230Vac.
Mains Okay
Manual Test
Auto Test
Zone not ready XX = Zone: YYYY Sensor
Description.
ENGLISH
Action to take
If the GSM signal is below 8, attempt to reposi-
tion the GSM antenna.
Verify if the SIM card is correctly inserted.
When armed the display will show DAY or
NIGHT
Check PSTN telephone line. If connected or if
faulty.
Check incoming mains service. If okay, check
1Amp. Delay action fuse in control panel. If
okay, check power supply input and output.
(see page 4 and 5 point 10)
Check if mains 230Vac. Is present.
Test of battery is efficient.
Check power supply output voltage if 13.8Vdc.
Normal battery life 3 to 4 years.
Control panel triggered: verify zone triggered
System control
Send SMS Immediate
Send SMS Immediate
Send SMS after 5 seconds
Send SMS after 5 seconds
Send SMS after about 10 minutes
Send SMS after 3 seconds
Send SMS after 3 seconds
Send SMS after 1 minute (see settings page 18)
Pag. 7