Table of Contents
Advertisement
ENGLISH
On the display will appear:
If you select "YES" and I proceed to arm the panel after I have exited the programming mode and this
zone is triggered the control panel will indicate on the display that the zone is "Not Ready" "Check"
and immediately there after you will see the zone that is trigger with the indication of the type of
sensor. After this will appear a request of forced arming indicated as "Not Ready Arm Any way"
"Y/N" at this point you must select if you want the panel to go ahead with the Arming just the same.
Leave this function on "CH" and press the keys
With the keys
or
this zone is triggered the buzzer inside of the keypad will emit a beep.
Note: To use the "Door Chime" zone, it is necessary to activate it with the panel disarmed by
entering, on the keypad, the end user password followed by the number 9 (See page 8). At the end
press the key
to continue and set the next zone or press the key
E
menu.
11. PROGRAMMING THE PEG-3 KEYCHAIN TRANSMITTERS.
Enter the main menu and go to the window "Programming sensors"
Press the key
E
On the display will appear:
Press the key
E
On the display will appear:
Press the key
to cancel the number that indicates the memory position of the Peg-3.
Select a new position and press the key
Pag. 22
Ready-To-Arm
YES NO
Sensor Status
OP CL
E
Door Chime
YES NO
select the "Door Chime" zone. With the Dualnet-6 disarmed, every time
Set Smart Zone
Pr
ogram Sensor
Zone Number
Group Number
to confirm.
E
to return to the main
#
The Zone 00 is associate with
the learning of the keychain
00
transmitter "Pegaso code" PEG-3
"Group Number" 0 is associate to
the 1st Peg-3 to be learned.
0
You may learn up to 10 different
Peg-3 codes.
DUALNET-6 MANUAL
Advertisement
Table of Contents
