Zone Settings - 3i Dualnet-6 Instruction Manual

09. ATTRIBUTING THE ZONES
Enter the programming menu and go to the window "Zone Attribute"
Press the key
E
On the display will appear:
To select the zone number to which you wish to attribute the sensor, you must press the key
and digit the number of the zone from 01 to 44 (you must always press 2 numbers). After the zone
has been selected on the display will appear the zone selected. Then press
the display will appear:
With the keys or
with the next display window (see the factory settings on table 1)
To select the type of sensor you must press
Follow the table 2 and 3 on the following page (insert a number between 00 and 15). At the end
press key to proceed to the next window.
E
With the keys or
to proceed to the next window.
E
With the keys or
you desire to proceed to the next window or press the key
DUALNET—6 INSTRUCTION MANUAL
PSTN Failure
Zo ne Attribute
Zone Number
Zone Type
2 1
select the group of belonging **; then press the key
Sensor Type
and digit the corresponding number.
Bypass Zone?
YES
select if the zone must be bypassed or not and then press the key
Entry Delay?
YES NO
select if the zone must be delayed or not, then press the key
01
to confirm and on
E
** Group Belonging:
0 = 24 hour
0
1 = Night arming (only parametric)
2= Day Arming (total)
E
01
NO
to return to the previous menu.
#
ENGLISH
to proceed
if
E
Pag. 19