Table of Contents
Advertisement
ENGLISH
.
On the display will appear:
ActivateSensor
Delete Sensor
To memorize
To Cancel
With the keys
or
ActivateSensor
Learning
If the panel memorizes the code the display will show "Memorized" if it
does not it will show "Failure". Press the key
above procedure
If the sensor code has been previously memorized, on the display
will appear "Update ?" By pressing
to a new position and memorized.
NOTE: If the password is in the same position, it may be cancelled.
If this takes place it must be again memorized.
Press once again
if you wish to memorize additional Peg-3
E
transmitters otherwise press
13 . ALARM REPORTS
Enter in the main menu and go to "Alarm History"
Press the key
E
On the display you will see:
By pressing the key
With the keys
or
smallest number indicated the last event. You may go up and down in the event log also with the key
E
. At the end press
#
Pag. 24
If you desire to cancel a wireless sensor select with the keys
or
appear. Press
ActivateSensor
Delete sensor.
E
Press
to proceed
select "Activate sensor" to learn a sensor's code.
From a distance of about 5 mt.
from the keypad and within 20
seconds, send a transmission,
from the sensor.
E
the sensor code will moved
E
#
to return to the main menu.
Program Sensor
Al
arm History
00:
00 Tamper
the display will show number date and hour of the event.
00:
12:00AM
the end user or installer may go up and down in the event log. The
to return to the main menu.
"Delete sensor" Delete Memorized sensor will
E
to cancel.
Deleting Sensor
Success
Success
ActivateSensor
and repeat the
Failure
00SensorExists
Update?
00 = is the number of the event
00 Tamper = is the zone in which
the Tamper is triggered.
00 = Number of the event
10.08
10.08 = Date of alarm trigger
12:00 AM = Hour of alarm trigger
DUALNET-6 MANUAL
Advertisement
Table of Contents
