Panel Functions - 3i Dualnet-6 Instruction Manual

18. Panel Functions:

With the control panel Disarmed, it is possible to Arm by pressing the correct number on the keypad
or wireless with a coded PEG-3 transmitter that has been learned by the control panel
2014 03 10
10 : 30 AM MON
1 2 3
4 5 T 6
7 8 9
0 #
To arm the panel in DAY mode with keypad:
The installation will arm with programmed exit time and check the zones with option
"Ready to Arm" on "Yes"
To arm the panel in NIGHT mode with keypad:
The installation will arm with the programmed exit time and check the zones with the
option "Ready to Arm" on "Yes"
To Disarm the panel with keypad:
If you wish to ARM the panel in Day mode without an exit delay time (immediate) in Day mode and
without taking into consideration if a zone is triggered. Digit on keypad the following:
If you wish to ARM the panel in Night mode without any exit delay time and without taking into
consideration if a zone is triggered. Digit on keypad the following:
The
zones that are triggered when the panel is being armed will be automatically by-passed
and will become active again if normalized. (see note no page 8)
The keypad service buttons, seen below, must be pressed for 2 seconds to trigger an alarm.
HOLD-UP
DUALNET—6 INSTRUCTION MANUAL
E
Password + 1
Password + 2
Password + 3
Password + 4
Password + 7
Keypad service buttons
FIRE
ENGLISH
With Button 1 you may
Arm and Disarm the
panel in DAY mode
With button 2, you
may Arm & Disarm the
control panel in
NIGHT mode
Led lights during
transmission
Button 3
EMERGENCY CALL or
Hold-up alert.
PEG-3
EMERGENCY
Pag. 27