Table of Contents
Advertisement
On the display appears:
ActivateSensor
Delete Sensor
To memorize
To cancel
With keys
or
ActivateSensor
Learning
If the panel does not learn the
code, the display will show "Failure" press the key
the above procedure once again.
If the Peg-3 code has been previously memorized, on the display will
appear "Update ?" By pressing
moved to a new position and memorized.
NOTE: If the password is in the same position, it may be cancelled. If
this takes place it must be again memorized.
Press once again
E
transmitters otherwise press
12. PROGRAMMING THE WIRELESS SENSORS
Enter the programming main menu and go to the window "Programming sensors"
Press the key
E
On the display will appear:
To select the zone number you must press the key
15 to 44. These are the 30 wireless zones available. On the display will appear:
Group
0-1-2-3 = this means that each zone
may memorize up to 4 sensor codes
and the number 0 to 3 will indicate the
order in which they have been
Learned in each zone.
Every zone can memorize 4 different sensors codes. The group number indicates the sequence of
memorization. Press
DUALNET—6 INSTRUCTION MANUAL
If you desire to cancel a Peg-3 transmitter already memorized,
press the keys
sensor". Then press
ActivateSensor
Delete sensor.
E
Press
to proceed.
select "Activate sensor" to learn the Peg-3 "Pegaso" code.
With the Peg-3 keychain transmit-
ter press the Arm button and
send
transmission
seconds. See page 27.
E
E
the Peg-3 transmitter code will
if you wish to memorize additional Peg-3
#
to return to the main menu.
Set Smart Zone
Pr
ogram Sensor
Zone Number
Group Number
to cancel the previous number select a new number and confirm.
or
until the Display shows: "Delete
E
to confirm.
Deleting Sensor
Success
Success
with-in
20
and repeat
ActivateSensor
Failure
00SensorExists
Update?
The zone 00 is associated to
the Peg-3.
must not be used for the
00
wireless sensors.
the zones from 15 to 44.
2 times and then select a zone from
NOTE: If the end user wishes to know
which sensor has triggered the alarm,
0
low battery or tamper, it is best to
memorize only 1 sensor in each zone.
ENGLISH
So the zone 00
Use only
E
Pag. 23
Advertisement
Table of Contents
