How To Navigate In The Dualnet-6 Programming Menu; To Enter Into Programming Mode; To Exit The Programming Mode - 3i Dualnet-6 Instruction Manual

ENGLISH
HOW TO NAVIGATE IN THE DUALNET-6 PROGAMMING MENU
The following keypad buttons are used to navigate with-in the program.
#
To Confirm and to exit the programming mode.
To Cancel in case of error.
To move upward in the menu. Previous page.
To move downward in the menu. Next page.
01. TO ENTER INTO PROGAMMING MODE
Be sure that the control panel is disarmed before you digit on the keypad
Enter the factory installed Password (1234) and confirm with

To exit the programming mode

For example, when you are in the programming mode:
Press:
With this command the control panel will return to the armed mode.
NOTE: To avoid a Tamper alarm trigger, before exiting the programming mode, remove the
tamper jumper and connect to plug (1) the S1 female connector of the tamper switch and fix
the control panel cover.
Note: If the control panel remains in the programming mode and no keypad command
is received, after 2 minutes the control panel will automatically return to disarm mode.
Pag. 12
Enter Code
E
one Numbers
Ph
Rec Message
one Numbers
Ph
Rec Message
#
#
. On the display will appear:
DUALNET-6 MANUAL