Configuring Display Output From Lifesize Phone - LifeSize Room 200 Installation Manual

Configuring Display Output from LifeSize Phone

If you are using LifeSize Phone and your display shows the initial configuration screen but
the image is distorted and unusable or the display is blank, you can configure the display
from the LifeSize Phone user interface. Follow these steps:
1. Ensure that no calls are in progress.
2. Log in to the Admin Menu on your LifeSize Phone.
a. Press
b. Enter the administrator password (1 2 3 4 by default) and press
3. Press 1 on the keypad to select Preferences.
4. Press 1 on the keypad to select Display 1.
5. Press the
6. Press the
Note: If you remain idle on any preference screen for two minutes, you return to the
main screen.
7. When you have finished setting preferences, press the
8. Press to return to the previous screen.
No Power
To troubleshoot a power problem, complete the following steps:
1. Disconnect the power supply unit (PSU) from the LifeSize codec and the AC source.
2. Plug an appliance you know works into the AC source to determine if the source works.
3. If the AC source works, plug the PSU into the AC source, but do not connect the PSU to
the LifeSize codec. If the green LED on the PSU illuminates, the PSU is probably good.
4. Disconnect the PSU from the AC source. Connect the PSU to the LifeSize codec.
Reconnect the PSU to the AC source. If the LifeSize codec fails to boot and the green
LED on the PSU dims, the codec may be the source of the problem.
24
sequentially when the phone is idle.
key to select Auto.
key to accept your change(s).
key to save them.
LifeSize Room 200 Installation Guide
.