8.2.4.2
Profile selection with remote REM A or REM B
●
Plug the plug into the remote or the ACS II controller.
●
LEDs (1) and (4) blink.
●
Use the bottom rocker switch (5) to select where the required controller profile is saved.
LED 1 = remote
LED 4 = ACS II control system
●
The relevant LED illuminates permanently, the other LED is off.
●
Press the "Horn" (2) and "+" (3) buttons on the speed selection and hold them down for 3
seconds to confirm the selection.
●
The system will switch itself off and restart automatically. During the process, the selected
profile will be saved both in the remote and in the electronics module.
45