Replacing The Head Lamp Bracket (Conventional Lighting System) - Invacare FDX Service Manual

8.5.5

Replacing the head lamp bracket (conventional lighting system)

Requirements:
● Phillips screwdriver size 2
● 8 mm socket wrench
Uninstalling the head lamp bracket:
● Loosen both of the cap nuts (1) with an 8 mm socket wrench and remove the head lamp with
the bracket from the rubber mounting.
● Not shown in the illustration are two Phillips head screws, with which the head lamp is secured
to the bracket. Loosen both of these Phillips head screws to remove the head lamp from the
bracket.
● Replace the bracket.
Installing the head lamp bracket:
● Assemble all parts again in reverse order.
● Tighten both screws hand-tight.
● Check all vehicle functions.
● Perform an approximate adjustment of the head lamp using the ratchet plate as a guide. The
final adjustment can be performed by the user according to the instructions found in the User
Guide.
62