8.13.2 Replacing or rotating the motor / gearbox unit sealing ring
CAUTION: Danger of crushing!
The motor / gearbox unit is very heavy. Danger of injury to the hands!
● Pay attention to the heavy weight.
Requirements:
● 10 mm socket wrench
Uninstalling the sealing ring:
●
Uninstall the motor / gearbox unit, as described in chapter 8.13.1.
●
Use the 10 mm socket wrench to loosen and remove the self-securing nuts (4) including the
washers.
●
Remove the carriage bolt, which secures the sealing ring (2).
●
Carefully bend the sealing ring apart and remove it.
Installing the sealing ring:
●
Install the sealing ring so that the square hole for the carriage bolt is on the inside of the
wheelchair.
●
Insert the carriage bolt through the sealing ring.
●
Install the washer and the self-locking nut.
●
Do not tighten the self-locking nut completely, as the motor orientation must be adjusted
during installation.
107