Invacare FDX Service Manual page 77

●
Use the 6 mm Allen key to loosen and remove the four hexagon socket head screws (3) on
both sides of the wheelchair.
●
Remove the screws and the washers.
●
Lift the tilt module (1) up off of its brackets (2).
●
If one of the seat tilt mounting brackets (2) are to be replaced:
Use the 6 mm Allen key to loosen both screws (4) on the corresponding side of the
wheelchair.
- Remove the screws and the washers.
- Remove the tilt mounting bracket.
●
If one of the seat frame mounting brackets (5) are to be replaced:
- Disassemble the seat frame mounting brackets as described in chapter 8.6 starting from the
section header "Uninstalling the seat frame ".
Installing the tilt module:
●
Install the tilt module in reverse order. Make sure that seat tilt mounting brackets (2) are
affixed with screws to the top holes in the seat frame brackets (5).
●
Tighten the connecting screws of the seat tilt mounting brackets and the seat frame mounting
brackets to
18 Nm.
●
When installing the cables again, make sure that they are placed in such a way that they
cannot be crushed or damaged in any position of the tilt module.
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
● Let a second person help you.
●
Install the seat.
●
Install all covers again.
●
Check all functions of the vehicle and go for a test drive.
77