8.2.3
Replacing the G-Trac module
Requirements:
● 10 mm socket wrench
● Side cutting pliers
● Cable ties
Uninstalling the G-Trac module:
●
Switch the electronics of the wheelchair OFF.
●
Remove the front, rear and right lateral covers, as described in chapter 8.1.1, 8.1.2 and 8.1.3.
The G-Trac module is located on the spring-seat of the right-hand spring.
●
Trace the cable of the G-Trac module (1) to the electronic module and disconnect it there.
●
Pull the cable out of the wheelchair. If necessary remove any attached cable ties.
●
Use the 10 mm socket wrench to loosen and remove the self-securing nuts (3) including the
washers.
●
Pull the G-Trac module (2) off of the carriage bolt (1) which is inserted in the spring seat.
42