Drive Program Selection After Component Replacement; Profile Selection With G90A Remote - Invacare FDX Service Manual

8.2.4 Drive program selection after component replacement

The drive program is saved in the REM remote, and also in the DX, ACS or ACS II electronics
module. If one of these two components is replaced, the system must be told which of the
components has not been replaced so that it knows which contains the current controller profile.
Note
The system allows normal usage of the mobility aid after component replacement only if the
profile is selected afterwards.
8.2.4.1

Profile selection with G90A remote

●
Connect the plug to the remote or the ACS II electronics system, respectively.
●
The display (1) will indicate that you should select a profile.
●
Use the arrow keys (2) to select the location where the desired controller profile is stored:
I = Remote
II = Electronic module
●
The display will indicate which profile you have selected.
●
Press the "Horn" key (3) and the "Drive Mode" key (2) and keep them pressed for 3 seconds
to confirm the selection.
●
The system switches itself off and starts again automatically. During this process, the selected
profile is stored in the remote as well as in the electronic module.
44