Table of Contents
Advertisement
STEP 6B - PREPARE CABINET OPENING WHERE THERE
ARE NO EXISTING UTILITY HOOKUPS
INSTALL ELECTRICAL CONNECTION
Disconnect electrical power at the fuse box or circuit breaker box
before installing dishwasher.
Failure to do so can result in death or electrical shock.
Method 1 - Direct Wire
1. Drill a 3/4" (1.9 cm) hole into the right-hand cabinet, or the right-hand side of the
back or floor of the opening. See following graphic for preferred and optional
locations.
NOTE: Wiring the dishwasher will be easier if the wire is routed into the opening
from the right-hand side.
b
2. Remove sharp or rough edges by smoothing or covering the edges of the hole
that the wiring passes through.
Wood Cabinet - Sand edge of hole until smooth.
Metal Cabinet - Cover edge of hole with grommet (not provided).
3. Route cable from power supply through cabinet hole (cable must extend to the
right, front side of cabinet opening). Extend cable to 6" in front of unit and tape
to floor. This will prohibit cable from moving when dishwasher is moved into
cabinet opening.
WARNING
Electrical Shock Hazard
a
a
Preferred Locations
b
Optional Locations
17
Advertisement
Table of Contents
