Manual Packtrack™ Calibration For Ds6400 Scanner Using Spy - Datalogic DS6400 Reference Manual

9
The last section summarizes the calibration status of each scanner.
--------------------------------------
SCANNERS STATE SUMMARY
--------------------------------------
Scanner E
Scanner F
Scanner J
Scanner K
Scanner L
Scanner M
Scanner N
Scanner O
Scanner Q
Scanner R
Scanner S
Manual PackTrack™ Calibration for DS6400 Scanner Using SPY
9.3.2
In a Master /Slave Reading Station working in PackTrack™ or Continuous operating mode,
the individual scanners can be calibrated using the SPY tool in Genius™.
Independently from the scanner position in the reading station (top, side, bottom, etc), the
general procedure is to place three barcodes along the scanline of the scanner as indicated
in the figure below. The order is not important but the relative position to the scanner reading
area is: one barcode in the center near position and two barcodes at the outer edges of the
reading area.
Figure 108 – Manual PackTrack™ Calibration Relative Code Positioning
96
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
Calibrated and verified
PackTrack™ Reference System
Figure 107 – PackTrack™ Reference System
DS6400 REFERENCE MANUAL