Datalogic DS6400 Reference Manual page 109

READING FEATURES
If there are any nodes that show as U or L, then you should Stop the
procedure and correct the problem. If the nodes respond with I, N, or C then
you can Continue with the procedure.
NOTE
To run each instruction press the Next button. The procedure repeats the steps asking to
change the PCT-8000 X position (i.e. always before the PS Line (reference point) and
parallel to a conveyor edge but changing to the left-hand edge and/or to the center of the
conveyor), until the procedure terminates. At the end of the procedure, only the Stop
button is active. Typically 3 passes are necessary.
9
93