Dryer Installation - Electrolux 6000 series Service Manual

Affinity horizontalaxis
Hide thumbs Also See for 6000 series:
Table of Contents

Advertisement

7. With the pedestal drawer open bor better access,
install the two #10 screws through the front brackets
in the pedestal into the washer base as shown in
Picture 9.
Picture 9
8. After closing the pedestal drawer, carefully move the
washer/pedestal assembly inot position.
NOTE: Because of the increased weight
caused by the addition of the pedestal, two or
more people may be required.
9. Excessive noise and vibration can be prevented
by properly leveling the washer/pedestal
assembly on a SOLID floor and tightening the
leveling leg lock nuts.
With the washer/pedestal assembly in its' final
position, place a level on top of the washer. Adjust
the pedestal leveling legs so the washer/pedestal
assembly is level front-to-rear and side-to side, and
stable corner-to-corner.
Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropiate leg
so the washer/pedestal assembly is SOLID on the
floor on ALL four pedestal legs.
After leveling the washer/pedestal assembly, adjust
the lock nut on each pedestal leveling leg against the
pedestal base and tighten with a wrench. Keep the
leg extension at a minimum to prevent excessive
vibration.
10.Refer to the Installation Instructions that came
with the washer to properly complete electrical,
water, and drain connections. If questions arise,
please refer to the Owner's Guide that came with the
washer for contact information.
1. Remove the dryer installation hardware from the
plastic bag as shown in Picture 1.
2. Attach the rear brackets to the pedestal with four
#10 screws (2 per bracket) as shown in Picture
10.
Picture 10
3. Attach the front brackets to the pedestal with
four #10 screws (2 per bracket) as shown in Picture
11.
NOTE: The spacer plates shown in Pictures 1 and 3
are not required for the Dryer installation.
Picture 11
NOTE: If the dryer was previously installed, disconnect
the power cord and the vent hose. Also make sure the
leveling legs are adjusted fully into the dryer.
22

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7000 series

Table of Contents