8. Start the washer.
•
Close the door and press Start/Pause. The washer
will not operate with the door open. The status
lights will blink, the signal will beep and “dr” will
be displayed as a reminder to close the door.
•
As a safety measure, the door will automatically
lock during the entire wash cycle and the Door
Lock indicator will be lighted.
•
To add a forgotten item to the wash drum, press
Start/Pause, open the door, add the item, close
the door and press Start/Pause to resume the
cycle. “PAU” will be displayed alternately with the
estimated cycle time.
•
If the cycle is interrupted during spin, it will take
approximately 2-3 minutes for the door lock to
release. DO NOT force open the door.
•
To stop the washer, press Cancel.
9. A signal will sound when the Signal option is selected.
Remove items from the washer when the cycle ends.
Cycle Selection
Turn the Cycle Selector knob to the desired cycle. For
best results, follow the fabric care label instructions on
items to be washed. To change the selection after the
cycle has begun, press Cancel before making another
choice. Just turning the knob to another selection will
not change the cycle.
Deep Clean Sanitary
Use the Deep Clean cycle for heavily soiled colorfast
items that should be washed in very hot water. Only the
Hot/Cold Temperature setting is available. The household
water heater should be set at a minimum of 120° F. If the
setting is lower, the cycle time will be extended by 30
minutes or more.
The wash water is heated by an internal boost heater to
a maximum of 152° F as the load tumbles for up to 90
minutes. “SAn” is displayed during the wash phase
alternately with the estimated cycle time. Cold water is
added to Cool Down the load prior to drain and spin. This
cycle will eliminate 99.999% of 4 common infectious
bacteria*. (If the cycle is interrupted while the water is
heating, the final temperature of the wash water may be
lower and sanitation may be reduced.)