Removing The Drive Motor; Removing The Speed Control Board Assembly - Electrolux 6000 series Service Manual

Removing the drive motor:

1. Disconnect the washer from the electrical supply
and remove the rear access panel and the belt.
2. Disconnect the electrical plug and the ground wire
from the motor.
3. Using a 5/16" socket remove the (4) bolts, two in the
front and two in the rear, that hold the motor to the
outer tub.
4. Slide motor forward while supporting to remove.
5. Reverse procedure to reinstall, making sure the belt
tracks in the center of the large pulley. Adjust by
moving belt on motor pulley if required.
Removing the speed control board
assembly:
1. Disconnect the washer from the electrical supply
and remove the front panel and rear access panel.
2. Disconnect the terminal plug from the lower front.
91