Component Resistance Chart; Water Fill Height; Electrical Requirements; Incoming Water Pressure - Electrolux 6000 series Service Manual

QUICK REFERENCE SHEET

Component resistance chart.

Water fill height 3.5 ± .5 "
No load, start position of permanent press cycle.

Electrical requirements.

Incoming water pressure.

Drain requirements.

Motor.

Water usages
Per fill
Per cycle
Based on 1 wash and 3 rinse fills
Electrical component
Dispenser valve soleniods
Door lock solenoid
Pump motor
NTC Thermistor dispenser
NTC Thermistor heater
Water heater
M1 TO M2
M2 TO M3
Motor
M1 TO M3
M4 TO M5
Circuit - Individual, properly polarized and grounded 15
amp. branch circuit fused with 15 amp. time delay fuse
or circuit breaker.
30 and 120 pounds per square inch (maximum
unbalance pressure, hot vs. cold, 10 psi.)
Drain capable of eliminating 17 gals (64.3 L) per minute.
A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
The standpipe height above the floor should be:
Minimum height:
Maximum height:
No load agitate wattage - Max 150
No load spin wattage - Max 550
4.23 gallons
16.92 gallons
8
Resistance 
@ 77F (25C)
800 ± 7%
1325 ± 10%
12 ± 7%
3K
4.8K
14 ± 10%
5.3 ± 7%
5.3 ± 7%
5.3 ± 7%
118 ± 7%
24 in. (61 cm)
96 in. (244 cm)