Table of Contents
Advertisement
Drain Hose Installation
The drain hose is field installed to allow hose orientation
to the left or right, up or down depending on location of
the house drain. The hose is shipped in the washer tub
with the spring clamp on the coupler elbow and drain
hose hanger installed on the end of the hose.
1. Remove the drain hose from the tub of the washer.
2. Push the hose onto the drain coupler at the upper left
of the washer back panel until the hose contacts the
STOP RIB.
STOP RIB
DRAIN HOSE TAB
SPRING
CLAMP
PROVIDED
ON HOSE
PUSH HOSE
INTO COUPLER
TO STOP
3. Using pliers, squeeze the ears of the spring clamp
and position the clamp so the clamp ears align with
and contact the tabs on the drain hose. This assures
proper location of the clamp to prevent leaks.
ALIGN SPRING
CLAMP EARS WITH
TABS ON HOSE
ORIENT HOSE
TO RIGHT,
LEFT, UP
OR DOWN
AS NEEDED
BEFORE
PLACING
TABS
CLAMP IN
POSITION
ALWAYS ALIGN CLAMP
EARS WITH TABS
ON HOSE
Page 17
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Table of Contents
