Removing The Heater Control Board; Removing The Light Transformer; Removing The Light Socket - Electrolux 6000 series Service Manual

Removing the light transformer: (Select
models)
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Unplug the wires from the transformer.
3. Remove the (2) screws holding the transformer to
it's mounting bracket and lift the transformer out.
Removing the light socket: (Select mod-
els)
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Disconnect the (2) wires from output side of the
transformer.
3. Release the bellows from the front panel.
4. Push the light socket holder out of the rear of the
bellows.
Note: When reinstalling, make sure the socket is
completely seated into the bellows.
Removing the transformer and heater
control board mounting bracket:
1. Disconnect the washer from the electrical supply,
remove the top panel and release the console.
2. Remove the light transformer and the heater control
board.
3. Using needle nose pliers, release the mounting
bracket from the control mounting brace.
Removing the console mounting bracket:
1. Disconnect the washer from the electrical supply,
remove the console and front panel.
78