Removing The Pressure Switch; Removing The Electronic Water Level Sensor - Electrolux 6000 series Service Manual

4. Remove (4) screws to release the housing from the
pump.
Removing electronic water level sensor:
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Unplug the wire harness from the sensor.
3. Turn the sensor one quarter turn to release it from the
side panel and pull out on the pressure switch.
4. Disconnect the hose from the sensor.
Removing the heater control board:
(Select models)
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Unplug the wire harness from the heater control
board.
3. Remove the screw holding the heater control board
to its mounting bracket.
4. Release the (2) tabs at the bottom of the board and
lift the board out.
77