Installation - Electrolux EW6FN428BC User Manual

Table of Contents

Advertisement

8
www.electrolux.com
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
1)
Water supply
Maximum Load
Spin Speed
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar).
If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic sys‐
tem, connect it to your domestic cold water storage system. Make sure not to exceed a dis‐
tance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water stor‐
age tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.

5. INSTALLATION

WARNING!
Refer to Safety chapters.
5.1 Unpacking
1. Open the door. Remove all the items
from the drum.
Accessories delivered
with the appliance may
vary depending on the
model.
2. Put the packaging element on the
floor behind the appliance and
carefully put it down onto its rear
side. Remove the polystyrene
Minimum
Maximum
2)
Cotton
Maximum spin speed
IPX4
0.5 bar (0.05 MPa)
10 bar (1.0 MPa)
Cold water
8 kg
1151 rpm
protection from the bottom.
CAUTION!
Do not lay washing
machine on its front.
3. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holders.
1
2

Advertisement

Table of Contents
loading

Table of Contents