Shimano BeastMaster 9000 Instruction Manual page 68

5
Safety Features
• Automatic Circuit Breaker
The motor will turn ON and OFF at 1 second intervals
if there is excessive load on the reel. This is normal.
When that happens, the circuit breaker will trip and
the display will flash. Leave it flashing for 5 minutes
to protect the motor. Learning data will be saved
even if the line is wound in or fed by hand. The motor
will start to operate again when the flashing stops.
Caution:
• When the breaker has been tripped, it will not be deactivated by turning
the power off and on again.
• Depending on the type of breaker action, it will take between 30 seconds
and 3 minutes for the breaker to deactivate.
• Battery Status Display
When battery voltage drops below 10.5V (13.5V for
the lithium-ion battery), or when the power cord is not
properly connected, the battery icon on the display
will flash. Check the connection first. If there is no
problem with the connection then the battery will
need to be charged.
68
• Technical Lever Breakage
Please refer to the Inquiries | After Sales Service
section to have the unit repaired if this error
message is shown in the display.
* Do NOT wind or unwind the line when this
message is displayed. Line Learning will be inaccurate.
• If Voltage is Too High
This error message will be displayed if a voltage
of more than DC28V is applied. Please check
the power source and make sure that it provides
between 12V~24V.
• Inaccurate Line Learning Operation
This error message indicates inaccurate Line
Learning. Carry out Line Learning again.
error