Shimano BeastMaster 9000 Instruction Manual page 12

When Electric Winding Load Display and Rig
Retrieval Time are ON
As shown below, the status is shown under the
Rig Retrieval Time
When Rig Retrieval Time is ON
and the line is being retrieved by
motor, the time remaining is
displayed.
Electric Winding Load Display
When Electric Winding Load Display is ON and the line is being
retrieved by motor, the estimated line tension is displayed.
Depending on the load, the number will vary between 0 and 9.
Caution: When the Electric Winding Load Display and Rig
Retrieval Time Display are ON, and the Bottom Depth Display
and Target Depth Display are ON, Bottom Depth Display and
Target Depth Display take priority in the middle row. However,
if the motor is in operation, the display automatically switches
to Electric Winding Load Display and Rig Retrieval Time Display.
Menu R / S
(Rakuraku/Fixed Speed)
Press to switch between Rakuraku Mode and Fixed
Speed Mode. You can press this button even when
reeling in.
Press
The mode selected will be shown on the display.
R (Rakuraku Mode): Green Backlight
S (Fixed Speed Mode): Orange Backlight
The Menu Screen is displayed.
Various settings can be changed from the Menu.
See the diagram to the right for how to operate the
Hold
Menu Screen.
12
Current Depth
display.
Current Depth
Button
Basic Menu Screen Operation
Press and hold the MENU button for 3 seconds and you will hear two short beeps and
the Menu Screen below will appear.
Menu Screen
Scroll through the list by moving
the cursor up or down. For the
list of functions with settings
that can be changed from the
Menu, see the next page of this
manual.
Cursor
Highlights the menu item.
Use the cursor to select
the function.
Displays the functions of
the buttons. Please use
this as a guide for
operation.
These buttons move the cursor up or down.
When setting values, they are used to increase or
decrease the value by 1..
To return to the Water Depth Display, select RETURN from the Menu Screen and press SET.
水深画面に戻る場合はメニュー画面から「水深画面へ」 を選択し、決定してください。
また、モーターでの巻き上げ、もしくはハンドルで巻き上げますとメニュー画面から
If the motor or handle is used to wind up the line, the screen changes to the Water Depth Display
水深画面に戻ります。
from the Menu Screen.
メニューから設定変更できる機能の一覧は、次ページをご覧ください。
For the list of functions with settings that can be changed from the Menu, see the next page of this manual.
Charge Status
Indicates the charge of the
battery or the voltage of
the power supply as shown
below.
：
Adequate Charge
：
Slightly Flat
：
Insufficient Charge (Flashes)
▼ ▲ SET
Sets the function (or entered value)
selected by the cursor.