Adjusting Smart Line Depth - Shimano BeastMaster 9000 Instruction Manual

Adjusting Smart Line Depth

This function allows you to easily return your rig to the same depth
Smart Line
after repairing your line if it breaks.
Depth
* If you carry out zero setting when the depth display shows 10.1m or more, line breakage compensation will be carried out.
Hold
1
If you break your line, after repairing it,
lower your rig to the surface and press 0
Set for more than 3 seconds.
Caution
2
The display will change as shown above.
The computer will automatically return
your rig to the same depth it was at before
the line broke.
Always check that Jigging Mode is turned OFF before adjusting Smart Line Depth. If it is ON and jigging starts, then the
line can be wound in and cause unforeseen injuries.
Peep-Peep
Do NOT adjust Smart Line Depth with an
excessive amount of line wound onto the spool
as this can cause inaccurate line learning.
Caution
39