Handling Instructions - Shimano BeastMaster 9000 Instruction Manual

Handling Instructions

This reel consists of precision electrical components. Please read and
follow the instructions below. Proper maintenance after every fishing trip
is recommended to ensure that you will be able to enjoy using the reel for
many years to come.
64
1
Caring for Your Reel
* Remove the power cord and
make sure that the reel has
completely cooled down before
you start any maintenance.
1. Tighten the drag.
2. Wash the outside of the
reel with water, using a wet
sponge to remove any dirt.
* Do not immerse the reel in
water.
3. Disengage the clutch to let out 2~3m of line while washing between
the spool and reel to get rid of the salt as shown in the diagram.
4. Loosen the drag completely and leave the reel to dry in a shady place.
* Wash or lightly brush the alligator clips using freshwater to get rid of
any impurities from seawater.
* Salt Build-Up in the Bearings
S A-RBs (Shielded AntiRust Bearings) are made from corrosion-resistant
material. However, that does not entirely prevent saltwater from
entering the bearings and leaving a build-up of dried salt. They will
not rust, but the rumbling sound that accompanies this build-up will
sound the same as if they were rusty. The remedy for this will depend
on the extent of the build-up, but you can either remove the SA-RBs
and rinse them with fresh water to remove the salt, or replace the SA-
RBs. It is recommended that you have the SA-RBs maintained regularly.
* Please detach the power cord from the reel when in storage.