CyberData 011111 series Operation Manual page 36

Web Page Item
Enable Push to Talk
3. After changing the parameters, click the Save button.
Operations Guide
Table 2-7. Device Configuration Parameters (continued)
Description
This option is for noisy environments. When enabled, the
microphone will be muted normally. When the button is
pressed and held, it will unmute the microphone and allow
the operator to send audio back.
NOTE: When Enable Push to Talk is enabled,
you cannot stop an active call with the call button. The
device on the other end will need to end the call.
NOTE: Enable Push to Talk will not work on
some older hardware.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Test Audio button to do an audio test.
When the Test Audio button is pressed, you will hear
a voice message for testing the device audio quality and
volume.
Click on the Test Relay button to do a relay test.
Click on the Test Microphone button to do a
microphone test. When the Test Microphone
button is pressed, the following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Reboot button to reboot the system.
930260L
Installing the VoIP Indoor Intercom
Parts List
CyberData Corporation
29