CyberData 011111 series Operation Manual page 27

2.2.8.2 Intercom with a Jumper
Complete the following steps to restore defaults on an Intercom that has a jumper and no RTFM
switch:
1. Put a jumper on JP11. See
2. Wait for the Intercom to announce the IP address.
3. Press and hold the Call Button (see
4. Release the Call Button and wait for the Intercom to reboot.
5. Remove the jumper and cycle power by unplugging Intercom and plugging it back in.
Operations Guide
Figure 2-17.
Figure 2-17. Jumper on JP11
Figure 2-18) until "restoring defaults" is announced.
930260L
Installing the VoIP Indoor Intercom
Parts List
CyberData Corporation
20