Specification - SureCall DualForce User Manual

Specifications
Problem
The Alert LEDs flash after the
initial activation period.
The Alert LEDs continue
to flash
Your signal booster has
no power.
Product Name
Uplink Frequency Range (MHz):
Downlink Frequency Range (MHz):
Input Impedance:
Maximum Gain:
Noise Figure:
VSWR:
Supported Standards:
AC Input:
Maximum Output Power:
Cable:
RF Connectors:
Power Consumption:
Operation Temperature:
Dimensions:
Weight:
FCC (USA):
20
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | sales@surecall.com
Resolution
Lower the dip switch above the blinking LED by 5dB (for example,
from 65 to 60) and monitor the bars on your cell phone to see
whether reception has improved.
The singal booster shuts down automatically, and then restarts after
60 seconds. Turn down the Cellular, PCS or LTE/AWS dial that is
oscillating dial that is to prevent the signal booster from shutting
down autimatically.
Verify that the switch on the power supply is turned on and red LED is ON.
Connect the power supply to an alternate power source.
Be sure the power source is not controlled by a switch that can remove
power from the outlet.
Check the green POWER LED on the signal booster. If it is OFF, return the
power supply to SureCall. Contact tech support at
1-888-365-6283 or support@surecall.com, or go to www.surecall.com
and log on to online support to receive an RMA.
DualForce
Cellular: 824-849 MHz
PCS: 1850-1915 MHz G Block Included
Cellular: 869-894 MHz
PCS: 1930-1995MHz G Block Included
50 Ω
65dB-Cellular / 72dB- PCS
5 dB
≤2.0
CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE and all cellular standards
Input AC110V, 60 Hz; Output: DC 9-20V
1 Watt EIRP
SC-400
N Female (both ends )
<40W
-4ºF to +158ºF
10.05" x 7.5" x 2"
8.05 lbs
RSNDUALFORCE