Table of Contents
Advertisement
To Achieve
attenuation
3 DB
7 DB
15 DB
21 DB
31 DB
Note: As you see from the table above, attaining the recommended indoor and outdoor antenna separation optimizes coverage significantly. Any reduced
antenna separation decreases the booster' cellular signal capabilities.
LEDs
A light-emitting diode (LED) appears above each DIP switch bank on the top panel of the
signal booster.
Designation
LED
LED #1
PCS Uplink
LED #2
PCS Down link
LED #3
LED #4
Cellular Downlink
LED #5
Cellular Uplink
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | sales@surecall.com
Set the DIP Switchs in the Same Bank as Follows...
SW2
SW1
(2 dB)
(1 dB)
ON
ON
ON
ON
ON
ON
ON
OFF
ON
ON
OFF = normal operation.
ON = PCS uplink warning. Power off booster
immediately.
OFF = normal operation.
ON = PCS downlink warning. Power off booster
immediately.
Power
Green ON or blink = booster is receiving power.
OFF = booster is not receiving power.
Red ON = oscillation has occurred for longer
than 15 minutes and the booster is shutting
down (see Automatic Shutdown on page 14).
OFF = normal operation.
ON = cellular downlink warning. Power off
booster immediately.
OFF = normal operation.
ON = cellular uplink warning. Power off booster
immediately.
Installing your Hardware
SW3
SW4
(4 dB)
(8 dB)
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
ON
Description
SW5
(16 dB)
OFF
OFF
OFF
ON
ON
17
Advertisement
Table of Contents
Need help?
Do you have a question about the DualForce and is the answer not in the manual?