Possible Faults - eka EKF 1111 E UD Use And Instruction Manual

Electronic Ovens rev. 0 __________________________________ EKF 1111 E UD – EKF 1064 E UD – EKF 1016 E UD

5. 5. 5. 5.4 4 4 4 Possible faults

Possible faults Possible faults Possible faults
Type o Type of fault f fault
Type o Type o f fault f fault
Control panel completely off
(the oven does not work)
Cooking cycle set and START
push button pressed: the
oven does not work
Humidity Cycle/ steam
activated: no humidity/steam
is produced in the cooking
chamber
Door closed: steam comes
out of the seal
The oven does not cook
evenly
Lighting lamp in the cooking
chamber does not work
The wording "Er1" "Er1" appears "Er1" "Er1"
on the temperature display
_________________________________________________________________________________________ page 23
Cause Cause
Cause Cause
- Incorrect electric connections to the
mains
- No mains voltage
- Thermal break safety device tripped
- Electronic card protection fuse (power)
burnt
- Door open or ajar
- Damaged magnetic sensor
- Incorrect connection to water mains
- Cut-off cock closed
- Blocked water inlet filter
- Damaged water inlet solenoid
- Seal not fitted correctly
- Damaged seal
- Handle prong loosened
- One of the motors is blocked or turns
slowly
- The motors do not go into reverse
- Heating element not powered or is
damaged
- Damaged lamp
- Damaged lamp feeder
- Break in the connection between the
cooking chamber probe – electronic
(power) card
- Damaged cooking chamber probe
Corrective action Corrective action
Corrective action Corrective action
- Check the mains connection
- Restore mains voltage
- Reset the thermal break safety device
- Contact a qualified technician
- Close the door
- Contact a qualified technician to repair
the sensor
- Check the connection to water mains
- Check the cut-off cock
- Clean the filter
- Contact a qualified technician to repair
the solenoid
- Check the seal fitting
- Contact a qualified technician to repair
the seal
- Contact a qualified technician to repair
the prong
- Contact a qualified technician to repair
the motor
- Contact a qualified technician to repair
the motor
- Contact a qualified technician to repair
the element
- Change the lamp
- Contact a qualified technician to repair
the feeder
- Check the connection to the electronic
card
- Contact a qualified technician to repair
the probe