Rear Panel - Watchguard DVR4ENTPACK4 Manual

1.3 Rear Panel

1) VIDEO IN (1 ~ 4)
Connect to the video connector of a camera.
Note:
The DVR will automatically detect the video system of the camera, please make sure that the
cameras are properly connected to the DVR and power is supplied before the DVR is turned on.
2) AUDIO IN (1 ~ 4)
Connect to the audio connector of a camera if the camera supports audio recording.
Note:
To record footage with video with audio, make sure the camera which supports the audio function is
connected to the same video‐in channel and audio‐in channel. For example, the audio data from
audio CH1 will be recorded with the video data from video CH1.
4) AUDIO OUT
Connect to a speaker with 1 mono audio output.
5) MONITOR
Connect to a CRT monitor for video output.
Note:
When both MONITOR and VGA are connected, press the left key ◄ on the DVR front panel during
DVR startup to force the video output via MONITOR. For details please refer to "4.5 Video Output
Switch" on page 20.
7) VGA
Connect to a LCD monitor directly.
Note:
When both MONITOR and VGA are connected, press the right key ► on the DVR front panel during
DVR startup to force the video output via VGA. For details, please refer to "4.5 Video Output
Switch" on page 20.
8) IR
(For Selected Models Only)
Connect the IR receiver extension line for remote control.
9) EXTERNAL I/O
This port is used to connect external devices (such as speed dome cameras or
external alarms etc).
For detailed I/O port PIN configuration, please refer to "APPENDIX 6 PIN
CONFIGURATION" on page 53.
10) LAN
Connect to Internet by LAN cable.
11) DC 19V
Connect to the supplied adapter.
12) Power Switch
Switch to "o" to turn on the power, and "|" to turn off the power.
7
BEFORE USING THIS KIT