Appendix 4 Dvr Battery Replacement - Watchguard DVR4ENTPACK4 Manual

APPENDIX 4 DVR BATTERY REPLACEMENT

DVR time reset after power failure, for example, caused by a power outage, will cause the disorder of
the recorded data, and users may have problems in searching the event clip they want. To keep the
DVR time from resetting, a non-chargeable lithium battery, CR2032, is installed in the DVR.
However, the DVR time might still get reset when the DVR battery is low or even running out of power.
If so, please replace the DVR battery, CR2032, right away as instructed below.
How to replace CR2032
¾
Note: The lithium battery, CR2032, is a non‐chargeable battery, and should be purchased separately. Please
replace only with the same or equivalent type battery in case of danger.
Step1: Stop all DVR recording immediately to prevent the disorder of the recorded data. Then, back
up the recorded data if necessary.
Step2: Power off the DVR, and disconnect the DVR power.
Step3: Remove the DVR cover, and find the battery on the mainboard.
Step4: Push the release as indicated below to remove the battery.
Step5: Get a new battery with the side of "CR2032" facing up, and install it to the mainboard. Step6:
Replace the DVR cover and connect to power.
Step7: Set DVR date & time, and resume recording. For details, please refer to "2.4 Date and
Time Setting" at page 10, and "5.2 Record" at page 19.
APPENDIX 4 DVR BATTERY REPLACEMENT
50