Replacing The Brake Roller - Fujitsu fi-6130 Cleaning And Maintenance

fi-6130 / fi-6230 Image Scanner Operator's Guide

5.3 Replacing the Brake Roller

1. Remove any documents from the ADF paper chute.
2. Open the ADF by pulling the ADF open lever and turning the ADF to the front.
3. Remove the Brake roller from the scanner.
1) Grab both sides of the Brake roller cover, and press to the inside and pull down (towards you), as shown in the
illustration below.
2) Lift up the right side of the Brake roller and remove the right side of the shaft. Then pull the left side of the shaft
out of its hole to remove it.
CAUTION
Be careful, the ADF may close and pinch your finger.
ADF open lever
TROUBLESHOOTING
CONTENTS MAP
TOP