Parts And Functions - Fujitsu SP-1120 Operator's Manual

Chapter 1 Scanner Overview

1.2 Parts and Functions

This section shows the names of the scanner parts.
■Front
Side guide
Guides the documents in the ADF
paper chute (feeder) in the sideways
as they are fed into the scanner.
ADF
Pulls and feeds the documents one
sheet at a time from the ADF paper
chute (feeder).
Open to replace consumables or clean
the inside of the scanner.
Stacker
Stacks up the ejected documents.
Stacker extension 1
Lift up towards you to adjust to the
document length.
Stacker extension 2
Lift up towards you to adjust to the
document length.
ADF paper chute (feeder)
Holds the documents to be scanned.
Chute extension 2
Pull out to adjust to the document length.
Chute extension 1
Pull out to adjust to the document length.
ADF release tab
Pull this tab to open the ADF.
Operator panel
Consists of buttons and indicators.
Used to operate the scanner or check the
status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 38).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
13