Konica Minolta bizhub 500 User Manual page 322

Finishing/Folding
– To set Group in offset output, touch [Group] and [Offset] to highlight
them.
– To cancel the setting, touch the key again to deselect it.
5
Touch [OK].
The Basic Screen will be restored.
6
Specify any necessary copy settings.
7
Press [Start].
The scan/print job will start.
Reminder
Finisher FS-510 trays gradually go up/down while printed materials out-
put, depending on the tray selected.With Saddle Stitcher SD-502 or Mail-
bin Kit MT-501, the operation of the trays become greater. DO NOT allow
any object to interfere with the operation of the tray around the finisher,
as any interference may cause damage to the finisher.
Finisher FS-511 tray 2 (main tray) gradually goes down while printed ma-
terials output. DO NOT allow any object to interfere with the operation of
the tray 2 (main tray) on the left side of the finisher, as any interference
may cause damage to the finisher.
Note
To cancel changes to the settings, touch [Cancel] on the Finishing
Screen.
To cancel all settings, press [Reset].
If no other setting is desired, the copy job can be started using the set-
tings currently specified without touching [OK] to return to the Basic
Screen.
bizhub 500/420
6
6-9