Installation Of The Lamp House - Barco DP2K-12C Installation Manual

Image 4-23
Close side cover
C
AUTION
lamp house. Neglecting this update will result in poor performance and short life time of the xenon lamp. See
procedure "Resetting the lamp parameters".
A realignment of the xenon lamp in its reflector is required after the installation of the xenon lamp in the lamp
house. See procedure "Realignment of the lamp in its reflector", page 35.
4.5

Installation of the lamp house

W
ARNING
C
AUTION
handled.
Necessary tools
Flat screw driver.
How to install the lamp house
1. Ensure the projector is switched off.
2. Remove the lamp cover.
3. Hold fast the lamp house by its handles and gently slide the lamp house into its socket. Note that the compartment is provided
with guides (G) to position the lamp house correctly.
R5905050 DP2K C-SERIES 10/07/2012
:
The "LAMP INFO" parameters MUST be updated after each installation of a xenon lamp inside the
:
This procedure may only be performed by qualified technical service personnel.
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
4. Lamp & Lamp House
33